Functions of Operating Keys
222
ZW-8000/7000/5000
User's Manual
7-3 Functions of Operating Keys
The following table lists the names and functions of the operating keys on the Sensor Controller:
Name
Function
RUN (operation) Mode
FUNC (adjustment) Mode
←
(LEFT) key
→
(RIGHT) key
Changes sub-display content.
Functions differently depending on the settings.
• Function display switching
• Numerical value digit selection
• Setting cancellation
↑
(UP) key
↓
(DOWN) key
key: Executes TIMING input.
key: Executes RESET input.
* These keys are available only if key
inputs for the hold functions have
been enabled in the FUNC mode.
Performing Hold with
a Key Input p.166
Functions differently depending on the settings.
• Selection menu switching
• Setting value selection
Mode switching key
Press and hold for two seconds or
more to enter FUNC mode.
• For operating mode switching,
“SWITCH” is displayed on the
main display and “OK/CAN” is
displayed on the sub-display.
Press the ZERO/SET key to
switch the mode.
If you press for less than two
seconds, the display shifts to RUN
mode task switching and the
threshold value setting menu.
Press and hold for two seconds or more to enter
RUN mode.
• For operating mode switching, “SWITCH” is
displayed on the main display and “OK/CAN” is
displayed on the sub-display. Press the ZERO/
SET key to switch the mode.
• When the mode is switched from FUNC mode
to RUN mode, “SAVE” is displayed on the main
display and “OK/CAN” is displayed on the sub-
display.
Press the ZERO/SET key to save the settings
and switch the operating mode.
Press the ZERORST/ESC key to switch the
operating mode without saving the settings.
If you press for less than 2 seconds, the display
shifts to RUN mode task switching and the
threshold value setting menu.
Also, this starts teaching to set threshold values
when setting a threshold value.
ZERO/SET key
Executes a zero reset.
Functions differently depending on the selections.
• Application of selection conditions and numeri-
cal values
• Switching to lower menus
ZERORST/ESC key
Hold down for at least two seconds
to cancel a zero reset.
Functions differently depending on the selections.
• Cancellation of selection conditions and numer-
ical values
• Switching to upper menus
Hold down for at least two seconds to jump to the
top menu on the FUNC mode.
Summary of Contents for ZW-7000 Series
