Omron ZR-RX70, User Manual

Page: 93 / 127

Setting Menus
ZR-RX70 User’s Manual
3
SETTINGS AN
D
MEASUREMENT
91
(9)-7 Level Settings
The Level Settings are the same as the Trigger Level Settings except that the Combinations include only edge
operations (and no level operation) and the Alarm Output can be set to Rising (from Cleared to Generated) and
Falling (from Generated to Cleared).
See the “Trigger Level Settings/Alarm Level Settings” p. 72. This section describes only how to specify
the Alarm Output.
(9)-8 Next Search
Moves the cursor to a position after the current cursor position where the search conditions are met (Set the
search conditions in Section (9)-7 Level Settings).
(9)-9 Prev. Search
Moves the cursor to a position before the current cursor position where the search conditions are met (Set the
search conditions in Section (9)-7 Level Settings).
Setting Selections available
(1) Alarm CH Sets the alarm output to be used for search.
Off: No alarm output is used for search.
Output 1 to Output 4: The specified output is used for search.
(2) Mode Sets the search mode.
↑
Rising : Finds an edge at which the alarm output changes from Cleared to Generated.
↓
Falling : Finds an edge at which the alarm output changes from Generated to Cleared.