54
Error Lists
Section 5-3
5-3
Error Lists
Communication Error
Note
1.
The host communication error is an error that has occurred during commu-
nications between the host computer and ID Controller.
2.
The lower communication error is an error that has occurred during com-
munications between the ID Controller and R/W Head. These errors are all
recorded in the ID Controller and their error codes and messages can be
read using a command from the host computer.
3.
These errors are all recorded in the ID Controller and their error codes can
be read using a command from the host computer.
Warning Code
System Error
Note The system error (error that stops the operation) can be displayed on the
monitor of the ID Controller but cannot be checked by the host computer.
Location
Error
code
Type
Condition
Host communi-
cation error
10
Parity error
Error occurs during communication between host com-
puter and ID Controller.
– Incorrect setting of communication format
– Malfunctioning due to noise
11
Framing error
12
Overrun error
14
Command input error
Wrong command format.
18
Frame length MAX error
Command or data length exceeding 266 characters.
Lower commu-
nication error
70
Data carrier communication error
Error during communication between R/W Head and DC.
– Setting error such as passing speed and distance
– Malfunctioning due to obstacle
71
Unmatching error
Read or write processing is not performed correctly.
72
Data carrier missing
DC does not exist in specified area when write/read com-
mand is executed.
7A
Address over
Address exceeding memory area of DC is specified.
When using MDS/MDL command, first address of the
area is incorrectly specified.
7C
R/W head not connected
R/W Head is not connected.
7D
Write protect error
Production date area or write-protected area is specified
for write command.
Warning Code
Name
Meaning
7B
Data carrier battery low
The voltage of the Data Carrier’s built-in battery is low.
76
Excessive number of Data Carrier overwrit-
ing operations
This warning will be returned when the data management
command (MDS/MDL) is executed if the number of Data
Carrier overwriting operations is 100,000 or over.
76
Data Carrier memory check error
This warning will be returned if a memory error is
detected when the memory check command (MDC) is
executed.
Error
code
Type
Condition
92
CPU error
May be due to an ID Controller error or the influence of noise. Turn OFF power once and then
turn it back ON again. Turn ON the reset input (if the error still persists, use the other ID Con-
troller).
93
Memory error
Summary of Contents for V600 RFID System
