12
Communications Specifications
Section 2-4
2-4
Communications Specifications
The communications specifications conform to RS-232C, and a general-pur-
pose factory computer or personal computer can be connected to the ID Con-
troller. The communications protocol conform to SYSWAY (SYSMAC host
computer system).
Host Computer Communications Specifications
Note
*Set by the internal DIP switch.
Checking the Version
The ID Controller version can be checked using the following method.
1,2,3...
1.
Turn ON the power suppy to the V600-CM1D.
2.
The version will be displayed on the monitor as shown below.
Standard
RS-232C
Transmission path connection Point-to-point
Communications method
Two-line, half-duplex
Synchronization method
Start-stop synchronization (stop bit = 1 or 2)*
Transmission rate
2,400/4,800/9,600/19,200 bps*
Transmitted codes
ASCII (7 bits) or JIS*
Communications control pro-
cedure
Point-to-point procedure
Error detection
Vertical parity (even/odd/none)*
Line length
15 m max.
Connector
XM2A-0901 (plug): 1 set is supplied with ID Controller
XM2S-0911 (hood): As an accessory
Recommended cable
5PX28AWG, 7 dia.
6
0
2
.
1
Summary of Contents for V600 RFID System
