9
System Configuration
Section 1-3
!Caution
The CS1W-CIF31 Serial Conversion Cable cannot be used to connect a com-
puter running the CX-Drive to the 3G3MV. (See the following note.).
Required
devices
SMARTSTEP
A Series
(R7D-AP)
R7A-CCA002P2 (2 m)
•
R7A-CCA002P2 (2 m) + RS-
232C 9-pin adaptor
Or
•
XW2Z-
@@@
J-CJ Serial
Communications Unit/Board
Connecting Cable + XW2B-
40J6-4A Servo Relay Unit +
XW2Z-
@@@
J-B7
SMARTSTEP A-series
Connecting Cable
CS/CJ-series Serial
Communications Board/Unit
Ver. 1.2 or later
Note
The Serial Gateway
Mode is used as the
serial communications
mode for the RS-232C
port.
W Series
(R88D-WT)
R88A-CCW002P2 (2 m)
•
R88A-CCW002P2 (2 m) +
RS-232C 9-pin adaptor
Or
•
XW2Z-
@@@
J-CJ Serial
Communications Unit/Board
Connecting Cable + XW2B-
40J6-4A Servo Relay Unit +
XW2Z-
@@@
J-B8
SMARTSTEP A-series
Connecting Cable
W Series
with MECHA-
TROLINK-II
(R88D-WN)
---
---
Connection type
PLC (MCH/NCF Unit) MECHATROLINK-II connection
Connection name
Via PLC (MCH/MECHATROLINK-II)
Via PLC (NCF/MECHATROLINK-II)
Configuration
Required
devices
SMARTSTEP
A Series:
R7D-AP
---
W Series:
R88D-WT
MECHATROLINK-II Cable
MECHATROLINK-II Interface Unit (JUSP-NS115 or FNY-
NS115)
W Series
with MECHA-
TROLINK-II:
R88D-WN
MECHATROLINK-II Cable
Connection type
Direct serial connection
PLC Serial Communications Board/Unit connection
Connection name
Direct
Via PLC (SCU/SCB)
CX-Drive
MECHATROLINK-II
CS/CJ-series
PLC
CS/CJ-series
MECHATROLINK-II
Motion Control Unit or
Position Control Unit
Servo
Servo
Peripheral port
Or RS-232C port
For Peripheral Port:
CS1W-CN226 (2 m) or
CS1W-CN22626 (6 m)
For RS-232C Port:
XW2Z-200S-CV (2 m)
XW2Z-500S-CV (5 m)
Or via network
RS-232C
Summary of Contents for SYSMAC CXONE-ALC-EV2 Series
