![background image](http://html1.mh-extra.com/html/omron/r88d-gt-series/r88d-gt-series_user-manual_742798352.webp)
5-65
5-16 User Parameters
5
Ope
rati
ng Func
tions
• Use this parameter to set the Servomotor’s allowable operating range for the position command
input range.
• An overrun limit error (alarm code 34) will occur if the setting is exceeded.
• The function will be disabled if the setting is 0.
• For details, refer to
Explanation of Settings
• The instantaneous speed observer can both increase the responsiveness and reduce vibration at
stopping by improving the speed detection accuracy for devices with high rigidity.
• The Inertia Ratio (Pn20) must be set correctly.
• The Instantaneous Speed Observer Setting (Pn27) will be 0 (disabled) if the Realtime Autotuning
Mode Selection (Pn21) is not set to 0 (enabled).
• Use this parameter to set the notch frequency of notch filter 2 for resonance suppression.
• The notch filter will be disabled if the setting is 1500.
• Use this parameter to set the notch width of notch filter 2 for resonance suppression.
• Increasing the setting will increase the notch width. Normally, use the default setting.
• Use this parameter to set the notch depth of notch filter 2 for resonance suppression.
• Increasing the setting will decrease the notch depth and the phase lag.
• Use this parameter to set vibration frequency 1 for damping control to suppress vibration at the
end of the load.
• Measure the frequency at the end of the load and make the setting in units of 0.1 Hz.
• Setting frequency: 10.0 to 200.0 Hz. The function will be disabled if the setting is 0 to 9.9 Hz.
• Refer to
on page 7-35 for more information.
Pn26
Overrun Limit Setting
Setting range
0 to 1000
Unit
0.1 revolution
Default setting
10
Power OFF
→
ON
---
Pn27
Instantaneous Speed Observer Setting
Setting range
0 to 1
Unit
---
Default setting
0
Power OFF
→
ON
---
Setting
Explanation
0
Disabled
1
Enabled
Pn28
Notch Filter 2 Frequency
Setting range
100 to 1500
Unit
Hz
Default setting
1500
Power OFF
→
ON
---
Pn29
Notch Filter 2 Width
Setting range
0 to 4
Unit
---
Default setting
2
Power OFF
→
ON
---
Pn2A
Notch Filter 2 Depth
Setting range
0 to 99
Unit
---
Default setting
0
Power OFF
→
ON
---
Pn2B
Vibration Frequency 1
Setting range
0 to 2000
Unit
0.1 Hz
Default setting
0
Power OFF
→
ON
---
Position
Position Speed
All modes
All modes
All modes
Position
Summary of Contents for R88D-GT series
