Omron NYB17-11, User Manual

Page: 144 / 244

Power Connector Wiring Procedure
Use the following procedure to wire the power connector.
1
Remove the sheath from the power supply wires.
7 mm
Precautions for Safe Use
Observe the following precautions to prevent broken wires.
• When you remove the sheath, be careful not to damage the conductor.
• Connect the conductor without twisting the wires.
• Do not weld the conductors. Doing so may cause the wires to break with vibration.
2
Insert a screwdriver in the small opening above the cable opening
1
to unlock the cable entry
and then push the wire all the way to the back of the cable opening 2 .
2
1
1
2
Pin Description
1 24 VDC
2 0 VDC
3
Remove the screwdriver.
Do not apply stress to the cable after you have connected the wires.
5 Installation
5 - 36
NY-series Industrial Box PC User's Manual (W553)