Item
Editing
Description
Data
range
Default
Power con-
sumption [W]
Not pos-
sible.
The power consumption of the Safety Control Unit
from the NX bus.
This setting applies to Units other than an Additional
NX Unit Power Supply Unit.
---
Depends on
the model of
the Unit.
Unit width
[mm]
Not pos-
sible.
Width of the Safety Control Unit.
---
Depends on
the model of
the Unit.
I/O allocation
settings
Not pos-
sible.
I/O allocation settings for the Safety Control Unit.
---
Unit operation
settings
Not pos-
sible.
There are no settings that you can edit for the Safety
Control Unit
---
5-3-3
Procedure to Change the Model of the Safety Control Unit
After you create the Controller configuration, you can change the model or unit version of the Safety
Control Unit without changing the saved settings information.
Use the following procedure to change the Safety CPU Unit. You can also change the model of a
Safety I/O Unit with essentially the same procedure.
1
Display the Slave Terminal Tab Page for the CPU Rack or Slave Terminal where the Safety
CPU Unit to change is located.
2
Right-click the Safety CPU Unit to change and select
Change Model
.
The Change Model Dialog Box is displayed.
5 System Configuration and Setup
5 - 10
NX-series Safety Control Unit User's Manual (Z930)
Summary of Contents for NX-SIH400
