Omron NJ501-1500, Connection Manual

Page: 10 / 56

5
．
Applicable Devices and Device Configuration
7
5.2. Device Configuration
The hardware components to reproduce the connection procedures in this document are as
follows:
Manufacturer Name Model Version
OMRON NJ-series CPU Unit
(Built-in EtherNet/IP port) NJ501-1500 Ver.1.10
OMRON Power Supply Unit NJ-PA3001
OMRON Switching hub W4S1-05C Ver.1.0
- 24 VDC power supply
(for Switching hub) -
OMRON Sysmac Studio SYSMAC-SE2[][][] Ver.1.15
- Personal computer (OS: Windows 7) -
- USB cable
(USB 2.0 type B connector) -
- LAN cable (STP (shielded,
twisted-pair) cable of Ethernet
category 5 or higher) -
OMRON Sensor Controller ZW-7000 Ver.2.020
OMRON Sensor Head ZW-S7030
OMRON Calibration ROM (Supplied with Sensor
Head)
OMRON
24 VDC power supply
(for Sensor Controller)
(24 VDC, 2.5A, 60W)
S8VS-06024
Precautions for Correct Use
Update Sysmac Studio to the version specified in this Clause 5.2. or to a higher version.
If you use a version higher than the one specified, the procedures and related screenshots
described in Section 7. and subsequent sections may not be applicable. In that case, use the
equivalent procedures described in this document by referring to the Sysmac Studio Version
1 Operation Manual (Cat. No. W504).
ZW-7000
24 VDC power
supply
(for Sensor Controller)
ZW-S7030
USB cable
LAN cable
NJ501-1500
(Built-in EtherNet/IP port)
W4S1-05C
Personal computer
(Sysmac Studio installed,
OS: Windows 7)
LAN cable
24 VDC power
supply
(for Switching hub)
Calibration ROM