![background image](http://html1.mh-extra.com/html/omron/nj101-10-series/nj101-10-series_user-manual_742200267.webp)
A-4 Setting Transmission Delay Time by
Actual Measurement
This section describes the procedure to set the transmission delay time that is measured and calculat-
ed in the actual network configuration to the CPU Unit.
Version Information
Project unit version 1.40 or later is required to set the transmission delay time by the actual
measurement.
Precautions for Correct Use
Make sure to confirm the followings before you perform the actual measurement. Otherwise,
the correct transmission delay time cannot be calculated.
• Connect all slaves, including disconnected and temporarily disabled slaves, to the network.
• If a ring topology is included, remove the cable connected to the end port of the ring.
1
Go online and click the
Edit Settings
Button for
Transmission Delay Time
in the master set-
tings.
The
Transmission Delay Time Setting
Dialog Box is displayed.
2
Click the
Calculate the transmission delay time from the measured value
Button.
Appendices
A-31
NJ/NX-series CPU Unit Built-in EtherCAT Port User's Manual (W505)
A-4 Setting T
ransmission Delay
T
ime by Actual Measurement
A
Summary of Contents for NJ101-10 Series
