![background image](http://html1.mh-extra.com/html/omron/k6pm-th/k6pm-th_user-manual_743374078.webp)
4 Monitoring the Temperature in Control Panel with the Main Unit and the Software Tool
4 - 2
K6PM-TH Thermal Condition Monitoring Device User’s Manual (H231)
4-1
Method of Monitoring the Tempera-
ture in the Control Panel
This section describes how to monitor the temperature inside the control panel.
When temperature monitoring is performed with the Main Unit by using an infrared thermal sensor, the
following measurement levels are present.
The methods that can be used for checking are as described below.
When the configuration of the infrared thermal sensor is registered in the Main Unit by the software tool
or communications, the Main Unit shifts to the monitoring mode at that point of time, and the measure-
ment and monitoring of the Main Unit starts automatically (there is no need to particularly perform the
"Start" operation for measurement and monitoring).
At the same time, logging is started by the software tool.
At this time, the measured value is displayed on the numeric display on the Main Unit front-panel.
4-1-1
Overview of Temperature Monitoring
Measurement level
Methods for checking
Main Unit
Software tool
Communications
Temperature of each seg-
ment and sensor internal
temperature
The segment display of
each sensor can be
switched on the Main Unit
front-panel.
Can be checked on the
Monitoring sensor
Screen.
• EtherNet/IP tag data
link communications
• EtherNet/IP CIP mes-
sage communications
• Modbus TCP communi-
cations
Differential temperature
per segment from the
K6PM-TH sensor internal
temperature
Not supported
Temperature of each infra-
red thermal sensor
Not supported
The past maximum value
can be monitored on the
Monitoring K6PM
Screen.
Not supported
Temperature of each pixel Not supported
The temperature can be
displayed when the cursor
is placed on the thermal
image on the
Monitoring
sensor
Screen.
• EtherNet/IP CIP mes-
sage communications
• Modbus TCP communi-
cations
Alarms of each Main Unit
(Alarms of all infrared ther-
mal sensors connected to
the Main Unit)
You can check if an alarm
has occurred on the alarm
bar and by transistor out-
put.
The occurrence of an
alarm can be checked on
the
Device List of K6PM
Screen.
The occurrence of an
alarm can be checked
from the Main Unit status.
4-1-2
Display on the Main Unit after Registration of Sensor Configura-
tion
Summary of Contents for K6PM-TH
