5. Installation and Wiring
5-2
5.2. Battery Connection
This product has a battery for memory backup to keep collected data upon blackout.
Precautions for
Correct Use
- The memory backup battery is a consumable item. When the battery's remaining capacity
becomes low, the device alarm indicator on the product's front end turns on and the battery
must be replaced to new one.
Precautions
- Before installing the EQ100, always attach the memory back up battery. Otherwise proper
data collecting may not be available upon blackout or power off, due to reset of the built-in
clock, loss of totalized information, and/or loss of collected data of the latest 1 hour.
The battery is attached inside the EQ100 top cover, while the battery connector is not attached
upon factory shipment. Before using the product, attach the battery connector using the
following steps.
1) Remove the top cover.
2) Attach the battery to the connector and place it inside the EQ100.
3) Close the cover.
The battery and the cable must be placed in the position shown in the figure.
Battery Connector
Attach the connector
Hold the non-slip
section of the
battery
compartment
cover while sliding
the cover to the
arrow direction to
remove it.