Omron CS1W-MCH71 -, Operation Manual

Page: 71 / 717

26
Basic Operation Flow
Section 2-1
2-1 Basic Operation Flow
This Section gives an overview of the procedures required to use a MC Unit.
OPR. Operation Flow Reference
Setup SECTION 3 Installation and Wiring
3-2 Installation
3-1 Nomenclature and Functions
3-4 Wiring
MC Unit
Setting Users Manual for CS/CJ Series
CPU Unit
SECTION 7 PC Interface Area
7-3 Allocations for the CPU Unit
SECTION 4 MC Unit Internal Data
Configuration and Setting
4-2 System Parameters
4-4 Position Data
SECTION 6 Programming
START
Install MC Unit
Set Unit No. for MC Unit
Connect Support Tool/CX-Programmer
Connect MC Unit with External Input Devices
Connect Servo Driver and Servomotor
Connect Servo Driver and MC Unit
A
Turn ON the Power to the PLC
Create the I/O table of PLC
Set MC Unit Allocation Area in PLC DM Area
Power OFF and ON the PLC
Use CX-Motion-MCH to set the system parameters,
transfer them to MC Unit, and save them to flash
Use CX-Motion-MCH to create motion programs and
position data. Transfer them to MC Unit and save
them to flash memory.
Turn ON the power to the PLC or restart MC Unit
to enable settings.