Omron CS1W-CLK12-V1, Operation Manual

Page: 290 / 312

273
Appendix B
Optical Fiber Cables with Connectors (Indoor Use Only)
The following Optical Fiber Cables are available with Connectors already attached. (These cables have power
supply lines and tension members, which aren’t used in the Controller Link Network.)
Note Special training is required to assemble Optical Fiber Cables
and connectors with epoxy adhesive. Contact your OMRON
dealer for details on other optical fiber cords and cables.
The Optical Fiber Cables listed here are for indoor use only.
Consult a specialist tradesman if cables with outdoor specifica-
tions are required.
Duplex Unit Connecting Cable
This cable is used to connect Controller Link Units (CS1W-CLK12-V1) used in duplex operation in a CS1D
System.
Name: Duplex Unit Connecting Cable
Length: 50 cm
Model number: CS1D-CN051
Note 1. This cable (CS1D-CN051) is used to connect Controller Link Units used in duplex operation. To con-
nect standard nodes, use an Optical Fiber Cable with a connector (S3200-CN
@@@ - @@ - @@ ).
2. Controller Link Units used in duplex operation can also be connected by a standard H-PCF cable.
(Use a cable no longer than the maximum allowable distance between standard nodes.)
Specifications Length Model
Optical Fiber Cable Connectors:
S3200-COCF2011
⇓
S3200-COCF2011
2 m S3200-CN201-20-20
5 m S3200-CN501-20-20
10 m S3200-CN102-20-20
15 m S3200-CN152-20-20
20 m S3200-CN202-20-20
Over 20 m S3200-CN-20-20
(Specify length (m) when ordering.)
Optical Fiber Cable Connectors:
S3200-COCF2011
⇓
S3200-COCF2511
2 m S3200-CN201-20-25
5 m S3200-CN501-20-25
10 m S3200-CN102-20-25
15 m S3200-CN152-20-25
20 m S3200-CN202-20-25
Over 20 m S3200-CN-20-25
(Specify length (m) when ordering.)
Optical Fiber Cable Connectors:
S3200-COCF2511
⇓
S3200-COCF2511
2 m S3200-CN201-25-25
5 m S3200-CN501-25-25
10 m S3200-CN102-25-25
15 m S3200-CN152-25-25
20 m S3200-CN202-25-25
Over 20 m S3200-CN-25-25
(Specify length (m) when ordering.)