![background image](http://html1.mh-extra.com/html/omron/cpm2c-s100c/cpm2c-s100c_operation-manual_742520037.webp)
15
System Configurations
Section 1-2
1-2-4
DeviceNet Interface
A CPM2C-S100C-DRT or CPM2C-S110C-DRT can be used as a DeviceNet
Slaves to create an I/O Link of up to 1,024 points (512 inputs and 512 outputs)
with the DeviceNet Master. The input and output areas used in the I/O Link
can be allocated independently and the data areas, starting addresses, and
size of these Read/Write areas can be specified freely. (The Read/Write areas
can be set in the PC Setup or using the DeviceNet Configurator.)
Explicit message communications can be initiated from the Master to read or
write data in any data area in the CPM2C-S.
Note
Refer to the
DeviceNet Masters Operation Manual
(W379) for more details on
OMRON DeviceNet Masters.
CS1, C200HX/HG/HE(-Z),
CVM1, or CV-series PC
DeviceNet Unit (Master)
DeviceNet Slave
As a DeviceNet Slave, the
CPM2C-S supports remote I/O
communications with up to 32 input
words and 32 output words as well
as explicit message communica-
tions.
DeviceNet transmission line
DeviceNet Slave
Expansion (I/O) Units (3 max.)
CompoBus/S transmission line
CompoBus/S Slaves
Summary of Contents for CPM2C-S100C
