74
Examples:
1. Enter:
*I 3000
Displayed:
3000–CE 10 00 LDX
#$1000
3003–FF 40 00 STX
$4000
3006–86 80
LDAA
#$80
.
.
.
.
.
.
3030–81 12
CMPA #$12
•
Disassembles and displays 20 lines of code starting from the specified
address.
2. Enter:
*I, I
↵
Displayed:
3032–26 02
BNE
$3036
3034–A7 00
STAA
$00, X
3036–39
RTS
.
.
.
.
3080–08
INX
•
Each time I,I is subsequently entered, the next 20 lines of code will be dis-
played.
Save Command
Purpose:
To transfer the specified block of data to port 1 in S format
Format:
S(start address).(end address)
Remarks:
Transfers the data stored from (start address) to (end address) in S format to the
port 1 buffer.
Example:
Step 1:
*S3000.300F
↵
Step 2:
Press the START/STOP switch.
Example Remarks:
The data stored from &H3000 to &H300F will be transferred to port 1. If a periph-
eral device other than the input terminal needs to be connected for the data
transfer, follow the peripheral data transfer procedure explained at the begin-
ning of this section.
Load Command
Purpose:
To load a data file in S format through port 1
Format:
L[(offset)]
Examples:
1. Enter:
*L
↵
Enter:
*L100
↵
Press the START/STOP switch.
•
Loads a data file in S format through port 1 and stores the file in memory.
2. Enter:
*3100.310F
↵
Displayed:
3100–CE 00 00 08 26 FD 08 26
3108–FD 86 55 97 17 CE 00 00
•
When an offset address is specified, the loaded file is stored in memory
starting from an address whose value is the specified address plus the
Monitor Mode Commands
Summary of Contents for C500-ASC04
Page 1: ...C500 ASC04 ASCII Unit Operation Manual Revised February 2001 ...
Page 5: ...iv ...
Page 7: ...vi ...