![background image](http://html.mh-extra.com/html/omron/c200hw-clk21/c200hw-clk21_operation-manual_742483231.webp)
206
Commands and Responses for Controller Link Units
Section 6-5
Wired/Optical (response)
The connection method for the Controller Link Unit (wired or optical ring). The
configuration is as follows:
Node Address (response):
The Controller Link Unit’s node address is
returned between 01 and 3E Hex (1 to 62).
Unit Address (response):
The Unit address set for the Controller Link Unit
(10 Hex + Unit number), is returned in hexadecimal. Even when there is a Unit
number setting error, the Unit address is returned.
Network Address:
The Controller Link Unit’s network address, as set in the
routing table, is returned in hexadecimal. When the routing table has not been
set, the address becomes 00 Hex.
6-5-5
CONTROLLER STATUS READ
Reads the Controller Link Unit’s controller status.
Command Block
Response Block
Parameters
Operating status (response):
The operating status of the data links as fol-
lows:
00 (Hex):
Data links inactive.
01 (Hex):
Data links active.
02 (Hex):
Local data links not active. (The data links are active in the net-
work, but the local node is not participating.)
Status 1, Status 4, Status 6 (response):
Not used by the Controller Link
Unit. Always set to 00 (Hex).
Connection type:
0: Wired
1: Optical ring
– : Not used
Bit
Maximum number of nodes
00: 32 nodes
01: 62 nodes
Maximum number of send words
0: 1,000 words
1: 4,000 words
Command
code
01
06
06
01
00
00
00
00
00
00
Response code
Command
code
Operating status
Status 1
Status 2
Status 3
Status 4
Status 5
Count 1
Count 8
Active node list
Status 6
Total 6 bytes
Total 8 bytes
8 bytes
Summary of Contents for C200HW-CLK21
