5-10
5-2 Warning Function
5
Maintenance Operations
5-2 Warning Function
• The following table shows the details of warning display and parameter correction.
Warning display
Target code
Condition
Base code
001/201
Frequency upper limit A061/A261
>
Maximum frequency
A004/A204/A304
002/202
Frequency lower limit A062/A262
>
004/204/304
Base frequency A003/A203/A303
*1
>
005/205/305
Output frequency F001, Multi-step speed reference 0 A020/
A220/A320
*2
>
006/206/306
Multi-step speeds 1 to 15 A021 to A035
>
009
Orientation speed setting P015
>
012/212
Frequency lower limit A062/A262
>
Frequency upper limit
A061/A261
015/215
Output frequency F001, Multi-step speed reference 0 A020/
A220
*2
>
016/216
Multi-step speeds 1 to 15 A021 to A035
>
019
Frequency upper limit A061/A261
<
Orientation speed
P015
021/221
<
Frequency lower limit
A062/A262
025/225
Output frequency F001, Multi-step speed reference 0 A020/
A220/A320
*2
<
031/231
Frequency upper limit A061/A261
<
Starting frequency
b082
032/232
Frequency lower limit A062/A262
<
035/235/335
Output frequency F001, Multi-step speed reference 0 A020/
A220/A320
*2
<
036
Multi-step speeds 1 to 15 A021 to A035
<
037
Jogging frequency A038
<
085/285/385
Output frequency F001, Multi-step speed reference 0 A020/
A220/A320
*2
< >
Jump frequency 1/2/3
± Jump width
A063 ± A064
A065 ± A066
A067 ± A068
*3
086
Multi-step speeds 1 to 15 A021 to A035
< >
*1. In this case, the base frequency is rewritten when correcting parameters. Change the data to a correct value
if a warning occurs. Otherwise, the motor may burn out depending on the value.
*2. Checks even if the frequency reference selection (A001) is set other than to the Digital Operator (02).
*3. The jump frequency is rewritten into the value of the subtraction of the jump width (lower limit) from the jump
frequency.
Summary of Contents for 3G3RX Series
