4-105
4-2 Function Mode
4
Func
tions
(These trips are caused by hardware.)
Multi-function Output Terminal ON Delay/OFF Delay
• You can set ON/OFF delay times for each output terminal.
• All output signals immediately turn on/off when the specified conditions are satisfied. Depending
on the selected signal, chattering may occur. In such a case, use this function to hold or delay the
signal.
• Set the parameters for individual output terminals (multi-function output terminals P1 to P5 and the
relay output terminal: six terminals in total). For the output terminals and the corresponding
parameters, refer to the table below.
Input Terminal Response Time
• You can set a sampling time individually for multi-function input terminals S1 to S8 as well as the
FW terminal. This helps remove chattering or other noise.
• If the terminal input becomes unstable because of chattering, increase the set value. The larger
the data value is, the slower the response time. A setting range of 0 to 200 is available, which
corresponds to approx. 2 to 400 ms.
No.
Error code
Description
1
E10.*
CT error
2
E11.*
CPU error
3
E14.*
Grounding protection
4
E20.*
Abnormal temperature due to cooling fan stop
5
E23.*
Gate array communications error
6
E25.*
Main circuit error
Output terminal
ON delay time
OFF delay time
P1
C130
C131
P2
C132
C133
P3
C134
C135
P4
C136
C137
P5
C138
C139
RY (AL*)
C140
C141
Function code
Item
Data
Default setting
Unit
C130/C132/C134/C136/
C138/C140
Output ON delay
0.0 to 100.0:
Set an ON delay time.
0.0
s
C131/C133/C135/C137/
C139/C141
Output OFF delay
0.0 to 100.0:
Set an OFF delay time.
0.0
s
Parameter No.
Function name
Data
Default setting
Unit
C160 to C167
Input terminal response time
0. to 200. (× 2 ms):
Can be set in increments of 1.
1
ms
C168
FW terminal response time
Summary of Contents for 3G3RX Series
