ENGINE, TANK, AND RADIO GEAR GAS/GLOW VERSION:
Note: If you have the electric version, scroll down to the Electric section for directions on how to install motor,
ESC and batteries.
1. Locate the fuel tank and assemble the stopper, fuel lines, and tank clunk according the photo below.
Carefully bend the vent line upward toward the top of the tank. If you are using a gasoline engine just leave
the vent open and do not run it to the muffler. Mount the tank to the fuselage using the two tie wraps and
foam padding to reduce fuel foaming. NOTE: The tank provided is sized for a glow engine. If you are using
a gas engine, you might consider using a 6-8 oz tank.
2. Install the throttle servo into the opening in the right hand side of the fuselage. The cutout is sized for a
typical mini servo. If required, trim the opening larger to fit your servo. Feed the wire through the tunnel
provided and into the receiver hatch area. Use an extension if required and pull it through the tunnel using a
string or nylon pushrod taped to the servo lead.
3. Install the aileron servos in the wing using extensions as required. Hint: Make a small cable clamp out of
scrap balsa to help hold the end of the servo wire near the root of the wing.
