Omnitronic XMT-1400 MK2, User Manual

Page: 22 / 28

22
•
EN
5
Setup
Making the connections
Prior to making or changing any connections, switch off the XMT-1400 and the units to be connected.
1) Install the unit on a plane surface.
2) Connect subsequent units with line level inputs (e.g. amplifier or mixer) via an RCA cable to the analog
RCA output on the rear. Make sure that the right/left occupation is the same at the devices.
3) Use the supplied power cable to connect the XMT-1400 to the mains.
Switching on/off
1) Switch on the XMT-1400 with the power button. The unit will automatically detect if a CD is inserted
(indication "READING"). If a CD is inserted, the display will shortly indicate the total number of titles and
the total remain time followed by information concerning the first title after the read-in. If no CD is
inserted "NO Disc" will be displayed.
2) Prior to switching the unit off, always terminate the playback with the button . Then press the power
button to switch off the unit.
Inserting/ejecting a CD
1) Insert the CD with the lettering facing upwards. After the read-in, the player will be set to pause on the
first title.
2) To change a CD, first set the player to pause with the button . While playing a CD, the CD drive is
locked against unintentional opening. Then eject the CD with the button [EJECT].
Loading/removing USB devices and memory cards
1) Insert USB devices into the USB port. To remove a USB device, disconnect it from the USB port.
2) Insert an applicable memory card with its contacts pointing downwards to the right so far into the card
slot, until it engages. To eject a memory card, slightly press it into the slot until it comes out and can be
removed.
3) Never attempt to remove data carriers in play mode. Otherwise damage or loss of data may occur.
Selecting USB devices and memory cards
To switch from the CD to a USB device or a memory card, press the selector switch CD/USB/SD. The unit
must be in pause mode. The LEDs will verify which source is active.
1) The first actuation of the button will select the USB port (indication "USB"). After the read-in (indication
"READING") the total number of titles will be shortly displayed. Afterwards information concerning the
first title will follow. The player will be set to pause on the first title. If no device is inserted "NO USB" will
be displayed.
2) The next actuation of the button will select the memory card slot. After the read-in (indication
"READING") the total number of titles will be shortly displayed. Afterwards information concerning the
first title will follow. The player will be set to pause on the first title. If no card is inserted "No SD" will be
displayed.
3) The next actuation of the button switches the unit back to the CD.