Omnitronic XFM-212AP, User Manual

Page: 18 / 24

18
5
INSTALLATION
Installation
The speaker systems can be placed as desired or put onto a speaker stand via the stand flange on the lower
side. Always install the PA system at a solid, plane, anti-slip, vibration-free, oscillation-free and fire-resistant
location. Make sure that the installation complies with the standards and rules that apply in your country. The
product must be installed securely and prevented from falling down.
Making the Connections
To avoid interfering noise, switch off the active speaker system or set the output controls to minimum prior to
connecting and disconnecting equipment. Be sure to use only high-grade cables.
1
The stereo input signals are internally mixed to a mono signal for the output SPEAKER OUT. Connect
the passive speaker here.
2
Input MIC INPUT connects a dynamic microphone via XLR or 6.3 mm plug, balanced and unbalanced.
3
Connect units with stereo line output (e.g. keyboard, CD player or laptop) to the XLR jack or RCA inputs
LINE INPUT .
4
At the XLR output LINE OUT the master signal of all channels is available. This output allows
connecting e.g. the input of another active speaker system for additional PA applications.
5
Finally, connect the supplied power supply cable to the corresponding input and the mains plug to an
outlet.
Inserting Batteries into the Microphone and the Remote Control
1
For operation the microphone requires two 1.5 V AA batteries. Remove the cover of the battery
compartment and insert two batteries as indicated in the compartment.
2
The remote control of the audio player is supplied with a battery inserted. An insulating foil between the
battery and the battery contacts prevents the battery from being discharged during storage. Prior to the
first operation remove the foil from the battery support on the rear side of the remote control. Otherwise
operation of the remote control is not possible.
If the range of the remote control decreases, replace the battery. For this
purpose, on the rear side of the remote control press the small bar with the
groove to the right and at the same time remove the battery support.
3
If the devices are not used for a longer period, please remove the batteries to prevent damage in case
of battery leakage.