00047147.DOC, Version 1.0
27/30
6 OPERATION
The operation of the two players is identical.
6.1 Switching on/off
1 Switch on the
XCP-2800
with the power button. The unit will automatically detect if a CD is inserted
("LOAD CD" is indicated). If a CD is inserted, the display will shortly indicate the total number of titles
and the total remain time followed by information concerning the first title after the read-in. If no CD is
inserted "NoDisc" will be displayed.
2 Prior to switching the unit off, always terminate the playback with the button
. Then press the power
button to switch off the unit.
6.2 Inserting a CD
1 To insert a CD, open the CD tray with the button
.
(control LED lights). The display will show "OPEN".
2 Insert the CD with the lettering facing upwards and close the CD tray again with the button . The
control LED will be flashing during the read-in
6.3 Basic settings
After switching on, continuous play and elapsed title time (indication "ELAPSED") will be active as basic
settings on both players. These settings can be changed.
6.3.1 Selecting the operating mode
In the basic setting continuous play, all titles of are played one after the other and the unit stops at the end of
the last title. Press the button SINGLE on the player or the button SGL/CTN on the remote control to switch
to single title play. Then the unit is set to pause at the start of the next title after playing a title and indicates
"SINGLE".
6.3.2 Switching over the time indication
1 As a basic setting, the display will show the elapsed time of the current title (indication ELAPSED)
numerically in minutes, seconds and frames (1 frame = 1/75 second). With the button TIME the time
indication can be switched over:
• first actuation of the button: remaining title time (indication REMAIN)
• second actuation of the button: total remaining time (indication TOTAL REMAIN)
• third actuation of the button: return to basic setting (indication ELAPSED)
2 In addition to numerical time indication, the playing time is indicated graphically by the length of the
bargraph. When set to ELAPSED, the number of segments of the bargraph will be increased with
increased playing time. When set to TOTAL REMAIN and REMAIN, the number of segments of the
bargraph will be reduced with increased playing time. The bargraph will begin to flash in its full length 20
seconds before the playing time is ending.
6.4 Selecting a title
1 For selecting titles use the buttons
and
which allow to skip one title or several titles in forward or
backward direction. Each time the button
is pressed, the unit will advance one title. By pressing the
button
, the unit will go to the beginning of the title and with each further actuation, the unit will go back
another title.
2 By pressing the button
+10
, the unit will advance 10 titles.
