00024203.DOC, Version 1.3
14/33
Rear panel:
(8)
Antenna connector B
(9)
Power supply socket
(10)
Audio output socket
(11)
Channel 1-4 output sockets
(12)
Antenna connector A
(13)
Microphone grille
(14)
Battery LED
(15)
ON/OFF switch
(16)
Battery cover
(17)
Antenna
CONNECTIONS
Connect the wireless receiver via the Audio Out-socket and a standard microphone lead with a microphone
input socket of your mixer.
Adjust the antennas vertically.
Plug the connection cable of the power-unit with the DC IN-socket. Plug the power unit into your outlet.
Inserting/Replacing the batteries
Please refer to the explanations under Operating Determinations.
Open the battery cover on the bottom and remove it.
If replacing the batteries, remove the old batteries from the battery compartment. Only replace complete
battery-sets.
Leaky or damaged batteries might cause cauterisation when in contact with the skin; therefore, use suitable
protective gloves.
Caution!
Danger of explosion when battery is replaced improperly.
Only replace by the same type or similar types recommended by the manufacturer.
Remove empty batteries in accordance with the instructions of the manufacturer.
Insert the batteries and make sure that the poles are correct.
Replace the battery cover and close it.