00058978.DOC, Version 1.0
19/22
aaaaaaaaaaaaaaaaaaaaaaaaaaa
aaaaaaaaaaaaaaaaaaaaaaaaaaa
aaaaaaaaaaaaaaaaaaaaaaaaaaa
aaaaaaaaaaaaaaaaaaaaaaaaaaa
aaaaaaaaaaaaaaaaaaaaaaaaaaa
aaaaaaaaaaaaaaaaaaaaaaaaaaa
aaaaaaaaaaaaaaaaaaaaaaaaaaa
aaaaaaaaaaaaaaaaaaaaaaaaaaa
aaaaaaaaaaaaaaaaaaaaaaaaaaa
aaaaaaaaaaaaaaaaaaaaaaaaaaa
aaaaaaaaaaaaaaaaaaaaaaaaaaa
aaaaaaaaaaaaaaaaaaaaaaaaaaa
aaaaaaaaaaaaaaaaaaaaaaaaaaa
aaaaaaaaaaaaaaaaaaaaaaaaaaa
aaaaaaaaaaaaaaaaaaaaaaaaaaa
aaaaaaaaaaaaaaaaaaaaaaaaaaa
aaaaaaaaaaaaaaaaaaaaaaaaaaa
aaaaaaaaaaaaaaaaaaaaaaaaaaa
aaaaaaaaaaaaaaaaaaaaaaaaaaa
aaaaaaaaaaaaaaaaaaaaaaaaaaa
aaaaaaaaaaaaaaaaaaaaaaaaaaa
aaaaaaaaaaaaaaaaaaaaaaaaaaa
aaaaaaaaaaaaaaaaaaaaaaaaaaa
aaaaaaaaaaaaaaaaaaaaaaaaaaa
aaaaaaaaaaaaaaaaaaaaaaaaaaa
aaaaaaaaaaaaaaaaaaaaaaaaaaa
aaaaaaaaaaaaaaaaaaaaaaaaaaa
Installation of the speaker system
Caution:
The loads have to be installed in a balanced way. The carrying capacity of the stand or speaker
stand must never be exceeded!
Install the speaker system via the flange on the speaker stand or via the TV pin on the stand.
Make sure that the maximum lifting height of the tube is never exceeded.
Lifted telescopic tubes always have to be secured with a secondary securing!
4.4 Installation on a wall mounting
Before attaching the speaker system, make sure that the installation area can
hold a minimum point load of 5 times the speaker system's weight.
The wall mounting must be installed out of the reach of people.
The durability of the installation depends very much on the material used at
the installation area (building material) such as wood, concrete, gas concrete,
brick etc. This is why the fixing material must be chosen to suit the wall
material. Always ask a specialist for the correct plug/screw combination
indicating the maximum load and the building material.
The wall mounting must always be installed via all fixation holes. Do only use
appropriate screws and make sure that the screws are properly connected
with the ground.
The wall mounting's maximum service life must never be exceeded.
Procedure:
Step 1:
On the wall-mounting, there are holes for the installation.
Step 2:
Hold the wall mounting onto the location where it is to be installed.
Step 3:
Mark the boreholes with a pen or a suitable tool.
Step 4:
Drill the holes.
Step 5:
Hold the wall mounting in the desired position and tighten the screws.
Step 6:
Install the speaker on the wall-mounting.
4.5 Suspended installation
This speaker system must never be suspended - Danger to Life due to crashing
speaker systems!
