00048594.DOC, Version 1.0
20/23
5.5 Mounting the target light
Take the target light out of one of the two lateral polystyrene wrappings and plug it into the corresponding
RCA jack (Fig. 9). The target light activates automatically when switching on the power. Adjust the light freely
in a range of 360°. Caution! Never connect any other plugs, e.g. mixer inputs etc. to this jack! Otherwise,
danger of heavy equipment damage.
Fig. 9 Connecting the target light
6. CONNECTIONS
Prior to connecting or changing existing connections switch off the turntable.
1. Connect the analog audio output of the turntable with the supplied RCA cable to the line level input jacks
at the amplifier or mixer. Make sure that the right/left occupation (plug color red/white) is the same at
both units.
2. Connect the supplied power supply cable to the corresponding input of the turntable and the mains plug
to a power outlet. The unit is allowed to be operated with an alternating current of 80 - 260 V, 50/60 Hz.
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation. The device
must only be connected with an electric installation carried out in compliance with the IEC standards. The
electric installation must be equipped with a Residual Current Device (RCD) with a maximum fault current of
30 mA.
7. OPERATION
7.1 Playing a record
1. Remove the protective cover of the stylus.
2. Switch on the turntable with the power switch. The target light lights up.
3. To select the speed, press the corresponding button:
• for 33
O
RPM the left button (basic setting)
• for 45 RPM the right button
• for 78 RPM both buttons simultaneously
To indicate the selected speed, the corresponding LED above the buttons lights up. For 78 RPM both
LEDs light up.
4. Put on the record. For single records, use the adaptor.
5. Open the locking lever for the tone arm to the right. To lift the tone arm, place the lever for the tone arm
lift to the rear position.
6. Seize the handle of the tone arm, and place the stylus above the beginning or the desired spot on the
record. Place the lever for the tone arm lift to the front position. The tone arm is slowly lowered onto the
record.
7. Press the start/pause button
. The turntable platter starts to rotate. While playing, the record can be
stopped at any place and be restarted with the button
.
8. To stop the motor press the button MOTOR OFF (red control LED extinguishes).
9. With the button REVERSE you can switch over the sense of rotation. For this purpose shortly press the
button. With the reverse run switched on, the red control LED lights up.
10. To stop the playing, lift the tone arm with the tone arm lift and put it back onto the tone arm support by
hand. Stop the turntable platter with the button
.
11. After use of the turntable, secure the tone arm with the locking lever.
Summary of Contents for DRT-1000
Page 2: ......
