28
5. INSTALLATION
Install the CD-player on a plane surface.
Make sure that the inclination angle will not exceed 15°, as the CD cannot be read correctly otherwise.
Connect the CD-player with the RCA-cable to your mixer via the Audio Out-sockets. Make sure that the
right/left occupation (plug-colour red/white) is the same at both devices.
CAUTION:
Make sure that the CD-player is switched off (power-switch in outer position) before you connect
it to the mains in order to avoid damages on your loudspeakers.
Make sure that the indication on the Voltage-selector corresponds to the available voltage in order to avoid
severe damages.
Connect your CD-player with the mains.
CAUTION:
Turn the amplifier on last and off first!
6. OPERATION
6.1 Setup
Switch the CD-player on via the Power-switch.
When the device is on and the tray has no disc, "NO DISC" appears on the display.
6.2 CD Slot In
Insert your CD in the CD Slot In. Make sure that you only hold the CD with 2 fingers on the edge. Avoid
touching the inside area of the CD.
You can recall all memorized Cue-points, samples and effect-parameters from up to 128 CDs after switching
the CD-player off. Therefore, you have to switch the CD-player on, press the Memory/Recall-button (LED on)
and insert the respective CD. The CD source code is read and the Cue-points, samples and effect-
parameters memorized before will be loaded from the memory. The display shows "Recall" until the loading
process is finished.
The CD LED is illuminated when a CD is inserted in the CD Slot In and the player is ready for use.
6.3 LCD-display
If the CD is improperly positioned,"ERR" or "NO DISC" appears on the display.
If the CD is properly positioned, the CD-player reads the CD.
The player jumps to the first track and is in the Pause-mode (Pause-symbol flashes). Please note that the
player automatically jumps to the section where the music starts.
Next to "T" the track number is displayed. The track remain time is displayed in M (MIN), S (SEC) and F
(FRAME).
By using the Time-button, the time-indication can be switched from track remain time (Remain) to total
remain time (Total Remain) to track playback time (Elapsed).
SINGLE
LOOP
RELOOP
PITCH
AUTO
CUE
ELAPSED
TOTAL REMAIN
1 2 3 4 5 6 7 8 9 0
CUE
T
M
EFFECT
S
F
