Omnitronic COMBO-150BT, User Manual

Page: 30 / 40

30
aaaaaaaaaaaaaaa
aaaaaaaaaaaaaaa
aaaaaaaaaaaaaaa
aaaaaaaaaaaaaaa
aaaaaaaaaaaaaaa
aaaaaaaaaaaaaaa
aaaaaaaaaaaaaaa
aaaaaaaaaaaaaaa
aaaaaaaaaaaaaaa
aaaaaaaaaaaaaaa
aaaaaaaaaaaaaaa
aaaaaaaaaaaaaaa
aaaaaaaaaaaaaaa
aaaaaaaaaaaaaaa
aaaaaaaaaaaaaaa
aaaaaaaaaaaaaaa
aaaaaaaaaaaaaaa
aaaaaaaaaaaaaaa
aaaaaaaaaaaaaaa
aaaaaaaaaaaaaaa
aaaaaaaaaaaaaaa
aaaaaaaaaaaaaaa
aaaaaaaaaaaaaaa
aaaaaaaaaaaaaaa
aaaaaaaaaaaaaaa
aaaaaaaaaaaaaaa
aaaaaaaaaaaaaaa
aaaaaaaaaaaaaaa
aaaaaaaaaaaaaaa
aaaaaaaaaaaaaaa
Installation on a Stand or Speaker Stand
1
Attach an appropriate TV pin to the top end of the stand and fasten it with
the handle at the side. Suitable TV pin: TV-35 TV-pin for speakers, No.
60000735.
2
Loosen the fixation screws of the legs. Pull the legs out until the cross struts
stand at a 90° angle to the legs. Tighten the fixation screws of the legs.
3
Install the speaker system via the flange on the speaker stand or via the TV
pin on the stand. Make sure that the maximum lifting height of the tube is
never exceeded. The carrying capacity of a stand or distance tube must
never be exceeded.
•
Stands or satellite systems must only be installed on a plane area with a
maximum inclination angle of 5°.
•
When using stands or satellite systems under the influence of horizontal forces, e.g. through wind, the
standing safety can be impaired. This is why additional safety measures like attaching ballast weights have
to be taken.
• If inclined tension cables or prolonged outriggers are used, the area of danger has to be marked or even be
blocked.
• Before lifting or lowering the telescopic tubes, you must always block a safety area around the stand or
satellite system. This safety area must have a diameter of 1.5 times the maximum height.
•
Lifted telescopic tubes always have to be secured with a secondary securing!
•
The total weight of the installation (=total weight of all individual parts) must never exceed the maximum
load of the installation area.
•
The stand has to be installed out of the reach of people.
•
An unintended movement of the load has to be avoided -
also in case of fire!
•
The installer is responsible for adhering to the carrying
capacity given by the manufacturer, the safety
requirements and the qualification of possible co-workers.
•
When people are located below the load, all necessary
safety measures have to be taken in order to avoid injury.
•
The personnel have to be instructed on the content of the
user manual and on the dangers related with operating
stands.
• Depending upon the individual installation spot, all
necessary measures against movement and for securing
the standing safety have to be created.
•
The installation is only allowed on carrying areas. In some
cases, an appropriate substructure, e.g. via a balancing
foot, has to be created. When choosing the installation
material, optimum dimensions have to be chosen in order
to secure maximum safety.
•
Speaker systems installed on stands or satellite systems
may cause severe injuries when crashing! If installing on
slippery surfaces, the legs must be secured with screws
or nails via the provided holes or an anti-slippery mat has
to be used.