Maintenance:
The WFS will require frequent cleaning of the inlet mesh
screen and periodic filter replacement. Watch for the follow-
ing indications of required service caused by plugged screen
or filters:
- Reduced water flow
- Pump is surging and straining
- Pump shuts down when filters are loaded and discharge
pressure reaches 45 psi
Troubleshooting
Pump will not start
- Check power is
ON
- Check the circuit breaker on the WFS unit is not tripped
- Check that GFCI on WFS unit is not tripped
- Correct voltage 115 VAC (+/- 10%)
- Check if pump is hot - thermo protection shuts down motor
at 230° F and restarts automatically when cooled down
- Check that outlet hose is not kinked
Pump will not prime
- Out of water supply
- Inlet screen is plugged - Clean inlet screen; operation with-
out this screen is not recommended
- Check for a large amount of sediment in filter housing.
Replace the 20 and 5 micron filters if required
- Suction hose has a serious vacuum leak
- Inlet or outlet hose has a sharp kink
- Pumping housing is cracked
4640 Campus Place #110 - Mukilteo, WA 98275
www.omnitecdesign.com
Water Filtration
Model OWF115
This commercial and industrial water filtration system is
designed for purification of waste water from portable
showers and similar sources at construction sites.
Omnitec Design, Inc.
4640 Campus Place #110 - Mukilteo, WA 98275
www.omnitecdesign.com
