Lock Installation Instructions
FLAT2
FECHA:
Pg.
6
/
12
ESP Rev 02
MORTISE INSTALATION
fig. 3
1. Place the batteries (2 fig.1) in the lock, to carry out this operation, remove the screws
from the interior panel (1) of the lock and install the 4 x 1.5VAA inside. Close the battery
holder cover (6) again.
2. Insert the square (3) or spindle into the outer face (2) and install the pin.
3. Install the M5x36 spacers (supplied in the extra bag), on the screws on the outer front
(2).
4. Insert the cables (5) through the hole in the Door, from the inside to the outside. Connect
the cables (5) with the cables from the outer front (2) cables (4), and house the cable
assembly inside the Door.
5. Approach the two fronts to the Door and match the spindle (3) with the interior latch or
latch.
6. Finally, install the two M5 screws (7) to fix both front
Ask Omnitec Systems or your distributor for information to help you choose the mortise lock
available for this model.
