Safety Label Position
Bottom
Front Panel
Cleaning
Caution: Shut off the main power prior to cleaning unit.
Cleaning mirrors
Use a cotton swab and rubbing alcohol to clean the internal laser mirrors.
Remember to twirl slowly and press gently. Applying to much pressure can
break the mirrors.
Cleaning frequency depends on the environment in which the fixture operates.
Cleaning case
Use a soft cloth and normal glass cleaner to clean the casing. Be sure to dry all parts
before plugging the unit back in.
Operating Modes
Note: User must turn on key control to emit laser
1. Stand-Alone Operation (Auto, Sound Active Mode)
Auto mode
The unit runs built-in program to change effects automatically. Set DIP switch
pin 10 to ON, other pins to OFF to run Auto mode
Sound Active mode
This unit has built-in program that will react to sound and music under Sound
Active mode. Set all DIP switch pins to OFF to run Sound Active mode
2. Master-Slave Operation (Auto, Sound Active Mode)
This mode allows user to link up to 32 units to run the Master-Slave operation.
In the Master-Slave operation one unit will act as the controlling unit and the
others will react to the controlling unit. Daisy chain your units via the standard
XLR microphone cables in the following configuration: ‘Out’ from the first unit to
‘In’ on the second, ‘Out’ from the second to ‘In’ on the third and so on.
Auto mode
To set the master: Set DIP switch pin 11 and 10 to ON, other pins to OFF.
To set the slaves: Set pin 1 to ON, other pins to OFF
Sound Active mode
To set the master: Set DIP switch pin 11 to ON, other pins to OFF.
To set the slaves: Set pin 1 to ON, other pins to OFF
3. DMX Operation
DMX operation gives the user freedom to create his/her own programs tailored
to their own individual needs. To run this unit in DMX mode, connect the unit to
any standard DMX controller via XLR connectors. Please consult DMX
controller manual to determine address.
DMX Signal Levels
DMX 512 LEVEL 0~255
*Laser effect Control
230 ~
255
Sound
Active
225 ~
229
Effect45
：
：
：
：
10 ~
14
Effect2
5 ~
9
Effect1
0 ~
4
OFF
There are 45 effects preset between value5 to 229. Select them by changing signal
level as above introduction.
Identification label
Certification label
Warning label
Laser aperture & aperture label
