6
Step 2 — Determine Rail Selection
Measure the vertical distance between
Mounting Holes on Display.
If distance is greater than 19” (48cm)
use the supplied Extended Rails.
1. Using the Small Hex Wrench
unscrew the Slider Retaining
Screws (8).
3. Using the Small Hex Wrench un-
screw the Rail Retaining Screws (4)
and remove the Standard Rail.
Rail
Retaining
Screws
Slider
Rail
Rail Retaining
Screw Holes
2. Pull to remove the Standard
Rail and attached Sliders.
Slider
Retaining
Screws
4. Replace with the Extended Rail,
insert the Rail Retaining Screws and
tighten.
Extended Rail Installation
(only if required)
7
Step 3 — Determine Width Configuration
Measure the horizontal distance between
Mounting Holes on Display.
See below for Width Configuration details.
Standard Configuration
Narrow Configuration
Range:
15 ¾” (40cm) to 38 ½” (98cm)
Range:
3 ½” (9cm) to 15 ½” (39cm)
Prior to adjustment, loosen Slider Retaining Screws.
