OmniMount Systems, Inc. • 8201 South 48
th
Street • Phoenix, AZ 85044
1-800-MOUNT-IT • www.omnimount.com
Once all mounting screws have been installed, square up the projector mounting plate, and then tighten the
mounting screws securely.
Caution:
Do not force or over tighten the mounting screws, or damage to the projector may occur.
Step 5
Slide the bottom projector mounting plate onto the previously installed top projector mounting plate. (Fig. 11)
Important:
Always secure projector plates by installing 3/8” screws (
G
) into holes on front edge of plates.
Additional security can be provided by installing small padlocks through security slots at the rear of the projector
plates. (Fig. 12)
Note:
Make sure that the cables don’t get pinched
while sliding the plates together.
Attach cables to the projector. Turn projector ON, and make pitch and keystone adjustments as
per the projector manufacturers instructions. For additional pitch/tilt, use the three adjustment
knobs on top of the PMD mount (Fig. 13).
Fig. 11
Fig. 12
Fig. 13
