Selecting OBD Parameters Sent
The parameter selection command starts with 'obd' and then list parameters, values of
which must be sent in SMS.
The current fuel volume is calculated at the terminal based on the data acquired via
the OBD bus, and the set tank volume.
Command text in SMS
Comments
Example
*obd speed voltage rpm
fuel rate temp key engine#
speed – speed
voltage – voltage of the on-
board power supply
rpm – engine RPM
fuel – volume of fuel in the
tank (l)
rate – fuel consumption rate
temp – oil temperature
key – ignition
engine – error indications
Check Engine
off – disable sending of all
parameters
*obd speed fuel# and *obd
off#
Response to command
Comments
obd. speed on, fuel on
obd. Disable all
only those parameters are listed, data of which
will be sent data
Data of all parameters are parameters
25
Setting Overview
