Omnicomm LLS 4, Manual

Page: 22 / 32

EN
21
Electronic version
Assembly instructions
Below we provide the list and order of steps to be taken:
1. Preparation to the installation on a fuel tank
2. Sensor preparation
3. Setting up the sensor with Omnicomm Configurator
4. Installation and connection of the sensor
5. Fuel tank calibration
6. Sealing
Preparation to installation on a fuel tank
1. Select a place for the sensor installation, taking in account the
following:
• The sensor installation place must be as close to the tank’s
geometric center and be the deepest place in the tank (Figure 1)
• The installed sensor must not be in contact with internal
equipment
Installation of two sensors in a fuel tank can significantly reduce
dependence of the fuel level from the angle of vehicle inclination.
Figure 1. Selection of the installation place for Omnicomm LLS sensor