Copyright ©2019 Omni-Rinse, LLC. All rights reserved
.
Rev. 06.01.2020
3
SECTION 2-A : CORE UNIT (MACHINE ONLY)
Model BTRS-1
3. Mount directly to wall using appropriate fasteners for wall type (toggle bolts for hollow wall sections, wood
screws for mounting directly to studs, etc.). Use minimum of (6) stainless steel fasteners
—
no smaller than
#10. Tighten fasteners until snug. Over tightening can cause steel to bend and distort shape of Stall.
4. Reassemble unit and proceed to Section 3 (pg. 6)
If mounting under bar top, shelving, or any obstruction more than 6”
deep, allow minimum 2” clearance above unit for removal of top cover.
(See Fig. A)
1. Using Stall as a guide, determine pilot hole locations, ensuring holes are level.
Minimum of (6) stainless steel fasteners - no smaller than #10 - required for
installation.
2. Self-stick rubber bumpers are included to provide a level mounting surface for
SECTION 2 : INSTALLATION OPTIONS
MODEL BTRS-1
Table Top Base
SECTION 2-A (pg. 3)
MODEL BTRS1-TB1
Core Unit
(Machine Only)
MODEL BTRS1-UB1
Underbar Bracket
The Cube
MODEL BTRS1-TC1 MODEL BTRS1-US1
Utility Station
SECTION 2-B : TABLE TOP BASE
Model BTRS1-TB1
If installing under bar top, shelving, or any obstruction more than 6” deep,
allow minimum 2” clearance above unit for removal of top cover. (See Fig.
A above)
1.
Using a 3/8” wrench, attach Base with (4) 10
-24 nuts (in some instances,
Base will come pre-attached). (See Fig. 1)
2. Reassemble unit and proceed to Section 3 (pg. 6)
SECTION 2-B (pg. 3)
SECTION 2-C (pg. 4-5)
SECTION 2-D (pg. 6)
Fig. 1
2”
Fig. A