6
DMAN-xxxx-xx (Rev x.x)
www.omnexcontrols.com
call toll free: 1-800-663-8806
Follow these steps to ensure that there is a radio link between the transmitter and receiver.
Refer to the
Light Legend
below for diagram details
If the receiver's (Link) light does not flash GREEN, follow the steps under
Download ID Code
below.
The ORIGA system is now ready for use.
1. Power the R100
If the (Active) light on the transmitter is flashing and the (Link) light on the receiver is flashing GREEN, a link between the
two exists.
Test the Transmitter / Receiver Link
Light Legend
Solid
Slow Flash
Fast Flash
Red Light
Green Light
Yellow Light
E-STOP
CONFIG
LINK
STATUS
SETUP
OUT
E-STOP
CONFIG
LINK
STATUS
SETUP
OUT
1. Install Batteries
Remove the battery cover on the back of the transmitter using a slotted screwdriver and insert 4 "AA" alkaline
batteries. Orientation of the batteries is embossed inside the battery housing.
2. Turn on the Transmitter
Refer to the
Light Legend
below for diagram details.
Power the Transmitter
If the transmitter's (Active) light does not flash, check the battery orientation.
To turn off the transmitter, press the Power [OFF] button or the [E-Stop] button.
NOTE:
For operation at temperatures below –10° C lithium batteries are recommended. Low temperatures reduce battery performance for both alka-
line and lithium types. Refer to the battery manufacturer’s specifications for detailed information on low temperature performance.
WARNING:
do not install batteries backwards, charge, put in fire, or mix with other battery types. May explode or leak causing injury.
Replace all batteries at the same time as a complete set and do not mix and match battery types.
A. Press [E-Stop] button
B. Press Power [ON]
button
C. Twist clockwise and
release [E-Stop]
button
C.
B.
A.
T110E Battery Housing
2. Power the T110E
