Channel
Function
Value
Description
8
Frost
0-255
No Frost To Frost
9
Focus
0-255
No Focus To Focus
10
Pan
0-255
0-540°
11
Pan Fine
0-255
0-1.8°
12
Tilt
0-255
0-270°
13
Tilt fine
0-255
0-1.8°
14
Motor Speed
0-255
Pan/Tilt Speed
15
Reset
0-13
Unused Range
26-76
Effect Reset
77-127
Pan/Tilt Reset
128-255
Complete Reset
16
Lamp control
32-63 Lamp Power Reduction
160-191
Lamp Off (5sec.)
224-255
Lamp On (5sec.)
7. Installation
Mounting the fixture in areas away from reach by unauthorized
personnel is always recommended. Before mounting the fixture
make sure that the area you are using can hold a minimum load
of 5x the Fixtures weight. You must always use a secondary
safety attachment, such as a safety cable. The OMEZ
TitanBeam
™ 2R is fully operational in any install position,
including: hanging upside down on a truss or by setting it on a
flat level surface. Always make sure that all fixture are kept at
least 0.5m away from any flammable materials.
8. Cleaning & Maintenance
For best results OMEZ TitanBe
am™ 2R requires routine cleaning
and maintenance. Excessive dust, smoke fluid, and particulate
buildup will degrade the performance and will cause the fixture to
overheat. The damage from this is not is not covered in the
manufacture warranty. Always make sure you unplug the fixture
before opening any covers for cleaning. Optical components should
be cleaned carefully and do not use any harmful solvents to avoid
damage. Remember to keep all air vents clean and free from clutter
that will prevents constant air flow.
When resetting fixture please allow an average of 20 sec. for the fixture to reset all
sensors and motors. Fixture will continue where it left off. The lamp will stay on so
there is no cool off wait time. Always remember if the light bulb turns of at any time
during operation there is a 5-10 minute cool down period before bulb ignites.
