OMEGAbilance Freestyle, User Manual

Page: 44 / 47

OPERATING MESSAGES
TO
EXPECTED OPERATOR
The total key has been pressed and the scale is waiting for the operator key to indicate on which
operator to close the ticket.
OPERATOR BLOCKED
The operator is blocked on another scale on which a closing operation is in progress (check if any
other employee is using the same operator key by mistake).
OPERATOR DISABLED
This message is displayed if a transaction is made with a disabled operator key.
SEARCH ZERO
It is displayed during the power on procedure of the scale. Check that there are no goods on the weighing
pan or that the pan is "blocked" by some foreign body.
REMOVE THE GOODS FROM THE PLATE
After a trade was made, there was no weight change or "zero" crossing.
RECEIPT CLOSED
Attempt to close an already closed receipt.
ILLEGAL TARE
This message is reported when an attempt is made to use a tare value that is not compatible with the
metric division of the scale: the tare must in fact be a multiple of the metric division. In order to still allow
you to use the item in question, after this signaling the PLU will be displayed setting the tare to zero.
LOT NOT FOUND
The operator has set an ENTRANCE number not present in the archive (message active only after
enabling the traceability functions).
ERROR MESSAGES
OUT OF PRINTER PAPER
It signals the end of the labels or the paper roll.
ERROR IN THE CREATION OF THE RECEIPT
An error has occurred in the management of operator receipts: switch the scale off and on again.
message reappears call the After-Sales Service.
If the
PRINTER ERROR
An error has occurred in the management of the scale printer: switch the scale off and on again. If the
message reappears, call the After-Sales Service.
PRINTER COVER OPEN
The printer cover is open. Press on it then to lower the head.
Page 44 of 47
Man. Use Freestyle-rev03