19 |
P a g e
Process
Input
The Process Input (Single & Dual) accept up to two 0-24 mA, 0-0.1 V
DC
, 0-1.0 V
DC
, or 0-10 V
DC
process inputs. To use
these features, change the Input Type selection to
Single Process
or Dual Process
and then choose the
Device
Range/Type
option in the side bar.
Note:
When using Dual Process, the Device Range/Type section is only available for Input 0. Input 1 is always the
same type as Input 0.
Warning:
Be sure to setup the unit before plugging in Process inputs.
RTD
Input
The RTD Input interface provides interfaces to type 100, 500, and 1000 ohm 385 Curve, 100 ohm 392 Curve, and 100
ohm 3916 Curve RTD devices in 2, 3 and 4 wire configurations. A single RTD connection is supported.
To use these features, change the input type to
RTD
using SYNC.
Voltage
Current
Pin 1
Input 1
Input 1
Pin 2
Input 2
Input 2
Pin 3
Ground 2
Ground 2
Pin 4
Ground 1
Ground 1
Figure 32
Figure 34
Figure 33
Rear view of Filed Connector Shown
