ONPC
EN
user MaNual
INSTALL GuIdE
1. Put the machine on a flat table.
2. Insert power plug into the corresponding electric socket and make sure that
working voltage comply with supplying voltage.
SAFETY OPERATION GuIdE
1. Before use, please read the introduction manual carefully;
2. Keep ties, jewelry, hair, etc. away from the machine to insure personal safety;
3. Do not place the machine near the heat sources or in the humid environment for a long time;
4. Please use the machine near the electric socket to unplug easily;
5. When cleaning the machine or repairing the damaged plug, please unplug it from the electric socket at first;
6. Machine must be far away from children and pets;
7. If the machine is not to be used for a long time, please cut off the electric power and unplug.
8. Do not shred cloth ,plastic ,metal and paper with staples, clips, gummed or wet paper.
9. Please cut off the power, when you clean the machine, it is better to use soft cloth with soft soap water or cleanser.
Do not let the liquor go inside of the machine. Do not use bleaching powder, gasoline and thinner to wash the
machine.
OPERATION GuIdE ANd REMARKS
1. Set the slide switch to ‘AUTO’, at the time, the machine is on standby; put the shredding paper, vertically into the
entry, thereafter, it starts up automatically and does shredding; it returns to standby automatically after finishing
2. When jamming caused by inserting too much paper, or want to withdraw the paper immediately at the normal
shredding, please set the slide switch to “REV”, at the same time, the machine does the reverse rotation for about 1
second and returns the paper that has not been shredded; then put the switch to “OFF”;
3. To ensure your machine has a long use life and exerts good shredding function, please refer notice the maximum
number of shred paper, (CD or credit card)
4. If the machine works continuously or spasmodically for a long time, it may pause because the inside temperature
increases continuously. After resting for a period of time, it can work again;
5. Please do not put clips, adhesive paper, adhesive tapes, or clothes into the paper entry in order to avoid damaging
the blades or lowering the shredding performance;
6. If you want to clean the wastebasket or the machine, or the machine is not to use for a long time, please cut off the
electric power and unplug the machine.
7. Set the switch to “FWD” position, at the same time, the machine is ready for cutting credit card, put the credit card,
vertically into the entry, then set the slide switch to “AUTO” position, when finish cutting.
8. When you want to shred CD, you should first unfold the cover board, then set the switch to “FWD” position, at
the same time, the machine is ready for cutting CD, put the CD vertically into the entry, then set the slide switch to
“AUTOF” position when finish cutting.
FuNCTION
Automatically shred paper credit card, CD through infrared and reverse paper by hand.
Two intakes, one for paper and credit card, another for CD.
Three sliding switch (AUTO/OFF/REV)
AUTO: the machine is ready for operation, shredding starts as soon as paper / Credit Card is inserted in the
paper entry.
REV position: the machine is ready for cutting CD and also it can set back paper
OFF position: the machine is out of working.
LED Indication: Blue for power and Red for overheating / overloading
It is easy to move machine equipped with universal wheels
Separated waste bin for CD is designed for environment protection
The machine stops automatically to prevent jam when overloaded. It also stops automatically when motor
overheats.
