background image

 

LAMP REPLACEMENT 

Switch the appliance off, disconnect from the power source and give 

it time to cool off. 

Press the face of the light in slightly and rotate anti-clockwise to 
remove. 
Check and replace with a same rated LED (G10, 220-240V, 3W). 
 

CLEANING

 

 

SAFETY PRECAUTION 
Before cleaning your rangehood or performing any maintenance, please ensure that the rangehood is turned off 
at the power point. 
Do not use abrasive cleaners to clean the rangehood. The use of warm soapy water and a cloth is recommended. 
Ensure that the rangehood is cleaned regularly, as a build-up of grease and fat may occur otherwise. 
The filters on the rangehood must be cleaned regularly to maintain efficiency, and prevent grease build up. It is 
recommended that this is undertaken every 4 – 6 weeks, depending on frequency of use. 
The filters can be cleaned with warm soapy water or a cloth, or they may be washed in a dishwasher. If washed in 
a dishwasher, discolouration may occur to the mesh and frame. 
Cleaning of the range hood must be performed as described above, otherwise there is a possibility of a fire hazard 
due to grease and fat build up. 
Carbon filters must be used when recirculating the air back into the room. These must be replaced every 4 - 6 
weeks, depending on the frequency of use. 

 

TROUBLESHOOTING 

 

 

 

Fault 

Possible Cause 

     Solution 

Light on, but 
motor does not 
work 

Fan switch turned off 

Select a fan switch position. 

Fan switch failed 

Contact Service. 

Motor failed  

Contact Service. 

Light does not 
work, motor 
does not work 

House fuses blown 

Reset/Replace fuses. 

Power cord loose or disconnected 

Refit cord to power outlet. 
Switch power outlet on. 

Oil leakage 

One way valve and the air ventilation 
entrance are not tightly sealed 

Take down the one way valve and seal 
with sealant. 

Leakage from the connection of U-shaped 
section and cover 

Take U-shaped section down and seal. 

Lights not 
working 

Broken/Faulty globes 

Replace globes as per this instruction. 

Contacts bad 

Re-set lights. 

Insufficient 
suction 

The distance between the range hood and 
the gas top is too far  

Refit the range hood to the correct 
distance. 

Ventilation too little/too much  

Adjust ventilation, open/close windows. 

Reviews: