7
Maintenance and Cleaning
Note:
Any electrical repairs to this appliance must conform to your local, state and federal laws. Please
contact the service centre if in any doubt before undertaking any of the above. Always disconnect the unit
from the power source before opening the unit.
External surfaces are susceptible to scratches and abrasions, so please follow the cleaning instructions to
ensure the best possible result is achieved without damage.
GENERAL
Cleaning and maintenance should be carried out when the appliance is cold, especially when cleaning.
Avoid leaving alkaline or acid substances (lemon juice, vinegar etc.) on the surfaces.
STAINLESS STEEL
The stainless-steel must be cleaned regularly (e.g. weekly) to ensure a long life expectancy. Dry with a
clean, soft cloth. A specialized stainless-steel cleaning fluid may be used.
Note
: Ensure that wiping is done along the grain of the stainless steel to prevent any unsightly crisscross
scratching patterns from appearing.
CONTROL PANEL SURFACE
The inlay control panel can be cleaned using warm, soapy water. Ensure the cloth is clean and well wrung
before using. Use a soft, dry cloth to remove any excess moisture left after cleaning.
Important
: Use neutral detergents and avoid using harsh cleaning chemicals, strong household detergents
or products containing abrasives, as these will affect the appearance of the appliance and potentially
remove any printing of artwork on the control panel which will void the manufacturer’s warranty.
GREASE MESH FILTERS
The mesh filters can be cleaned by hand. Soak them for about 3 minutes in water with a mild detergent and
then brush them gently with a soft brush. Do not apply too much pressure so as to avoid any damage.
Leave to dry naturally out of direct sun light.
Note
: Filters should be washed separately to crockery and kitchen utensils. It is advisable not to use rinse
aid.
INSTALLING GREASE MESH FILTERS
- Angle the filter into the slots at the back of the hood.
- Push the button on the handle of the filter.
- Release the handle once the filter fits into a resting
position.
- Repeat to install all filters.
Summary of Contents for ORU52GLED
Page 1: ...Instruction Manual Undermount Rangehood ORU52GLED ORU90GLED...
Page 11: ...1...
