Omega ORT9WXL, Instruction Manual

Page: 6 / 12

6
Installation
Method two (Mounting under a Cupboard):
1) The rangehood must be placed at a minimum distance of 65cm from the cooking surface. The
maximum distance should be 75cm for the best effect Drill 4 holes of Ø 6mm at the bottom of the
hanging cupboard.
2) Drill six Ø4mm holes at the bottom of the cupboard. Cut a minimum Ø120mm hole for the outlet
venting (if required).
3) Put the one-way valve on the rangehood (if required), then install the rangehood onto the bottom
of the cupboard, tighten the hood with enclosed 6 screws (M4*35mm).
4) Install the adjusted board on the bottom of the hood in order to keep out the gap between hood
back and cupboard.
Recirculating or Ducted Venting:
The rangehood can be installed to vent the exhaust fumes out of the room (ducted) or to recirculate the air
back into the room once it has been filtered (recirculating). To set the rangehood up to vent the exhaust
fumes out of the room, adjust the venting switches (internal between the fans) to ducted and connect
appropriate ducting to the one way valve.
To set the rangehood up to vent back into the room, remove the vent cover from the front of the rangehood
and adjust the venting switch to recirculating. Note that carbon filters must also be fitted to the fan inlets as
shown.
Operating Instructions
The controls are at the bottom front of the rangehood.
LIGHT CONTROLS:
Use switch 1 to turn the lights on (I) or off (0).
SPEED ADJUSTMENT:
Use switch 2 to adjust the fan speed from low (I) to high (III), and turn off (0).
NOTE : Always fully extend the slide-out when in use.
7
Cleaning
Safety Precaution
Before cleaning your rangehood or performing any maintenance, please ensure that the range hood is
turned off at the power point.
Do not use abrasive cleaners to clean the range hood. The use of warm soapy water and a cloth are
recommended.
Ensure that the range hood is cleaned regularly, as a build-up of grease and fat may occur otherwise.
The filters on the range hood must be cleaned regularly to maintain efficiency, and prevent grease build up.
The filter mesh is made of metal. It is recommended that this is undertaken every 4 – 6 weeks, depending
on frequency of use. The filters can be cleaned with warm soapy water or a cloth.
Cleaning of the range hood must be performed as described above; otherwise there is a possibility of a fire
hazard due to grease and fat build up.
Replacing the Lamps
WARNING : Before changing the lights, make sure that the appliance is unplugged from the power source
and that the lamps are cool.
• Remove the grease filter.
•
Locate the junction box, unscrew the screws on the junction box cover and then remove the junction
box cover. (Pic 1).
• Locate the LED lamp wire and remove it from the junction box. (Pic 2)
• Squeeze the spring mount on either side of the LED lamp to remove it from the rangehood. (Pic 3-
4).
• Reverse the procedure to install a new LED lamp. Use a lamp with identical specifications to those
below:
o
ILCOS-D Code: DBS-2/65-H-120/33
o
Rectangle Lamp
o
Max Wattage: 2W
o
Voltage range: AC 110-240V
o
Dimensions: