6
Installation Instructions
The cooker hood should be placed at a distance of 65-75cm from the
cooking surface for the best effect. See Pic 1.
Install the hook in a suitable place once the installation height is fixed,
and keep it vertically aligned. The fixed position of the inside chimney
bracket determines the location of the chimney.
Fix the outside chimney bracket on the outside chimney, and be sure
that the inside chimney can be adjusted in height freely, as well as being
able to fix the exhaust pipe (Not included in the rangehood). Afterwards,
install the exhaust pipe and chimney on the cooker hood. See Pic 3.
Lift the cooker hood onto the hook. See Pic 4.
Adjust the height of the inside chimney to the position of the inside
chimney bracket, and fix by screw. After adjusting the position, fix the
body with safety screws. See Pic 5.
Note
: The two safety screw holes are positioned on the back casing, with diameter of 6m.
Warning: Failure to install the screws or fixing device in accordance with these instructions may result in
electrical hazards.
7
Notice of Installation
Before installation, please ensure the area is clean, to avoid suction of the remaining bits of broken wood
and dust.
The canopy hood cannot share the same air ventilation ducting as other appliances, such as gas and
electric heaters.
The bending of the ventilation ducting should be ≥ 120°, parallel or above the exit vent, and should be
connected through the external wall.
After installation, make sure that the extractor is level to avoid grease collection at one end.
NOTE: Remove all protective plastic coatings from the stainless-steel surfaces before use.
Summary of Contents for ORC93XA
Page 1: ...Instruction Manual 90cm Canopy Rangehood ORC93XA ORC94XBA ...
Page 16: ...1 ...