Omega OMW25B, Instruction Manual

Page: 7 / 24

7
Installation Instruction
Please read the manual carefully before installation
1. This appliance is only intended for domestic use.
2. This oven is intended for built-in use only. It is not intended for counter-top use or for use inside a cupboard.
3. Please observe the special installation instructions.
4. The appliance can be installed in a 60cm wide wall mounted cupboard.
5. The appliance is fitted with a plug and must only be connected to a properly installed earthed socket.
6. The mains voltage must correspond to the voltage specified on the rating plate.
7. The socket must be installed and connecting cable must only be replaced by a qualified electrician. If the plug is no
longer to accessible following installation, an all-pole disconnecting device must be present on the installation side
with a contact gap of at least 3mm.
8. Adapters, multi-way strips and extension leads must not be used. Overloading can result in a risk of fire.
The accessible surface may be hot during operation.
Electrical connection
The oven is fitted with a plug and must only be connected to a properly installed earthed socket. The socket must only
be installed and connecting cable must only be replaced by a qualified electrician, and in accordance with the
appropriate regulations.
If the plug is no longer accessible following installation, an all-pole isolating switch must be present on the installation.
The fitted cabinet must not have a back wall behind the appliance. A gap must be maintained between the wall and
the base of the unit above. Specified gap size could be referenced by the diagrams.
Please note: Allow disconnection of the appliance after installation, by accessible plug or a switch in the fixed wiring.
Minimum installation height: 85 cm.
Do not cover ventilation slots and suction holes.
Note: Do not trap or bend the power cable.
Screw
Mounting Plate
Trim-kit plastic cover