2
Wiring the Data Logger
Wiring Options
Three-position removable screw terminal connections; accepts
3-wire configurations.
Warning: Note the polarity instructions. Do not attach wires to the wrong terminals.
Product Notes
LEDs
- Green LED blinks: 10 seconds to indicate logging and 15 seconds to indicate delay start mode..
- Red LED blinks: 10 seconds to indicate low battery and/or memory and 1 second to indicate an alarm
condition.
Password Protection
An optional password may be programmed into the device to restrict access to configuration options. Data
may be read out without the password.
Multiple Start/Stop Mode Activation
- To start device: Press and hold the pushbutton for 5 seconds, the green LED will flash during this time. The
device has started logging.
- To stop the device: Press and hold the pushbutton for 5 seconds, the red LED will flash during this time.
The device has stopped logging.
Alarm Settings
Programmable high and low limits; alarm is activated when current reaches or exceeds set limits.
Engineering Units
Engineering units are used to convert one measurement reading to another. The Omega software allows for
software level Engineering Units (conversion applied to data after download). Certain devices have device level
Engineering Units, which upon download automatically appear in the chosen unit of measure.
Installation Guide
Installing the Interface cable
- OM-CP-IFC200
Insert the device into a USB port. The drivers will install automatically.
Installing the software
Insert the Omega Software Flash Drive in an open USB port. If the autorun does not appear, locate the drive
on the computer and double click on
Autorun.exe
. Follow the instructions provided in the Installation Wizard
.
OM-CP-PROCESS101A
