Omega OF910FX, Instruction Manual

Page: 11 / 25

8
INSTALLATION
For LPG Connection
For LPG (cylinder) connection, affix a metal clamp on the hose coming from LPG
cylinder. Affix an edge of the hose on hose inlet connector behind the appliance
by pushing to end through heating the hose in boiled water. Afterward, bring the
clamp towards end section of the hose and tighten it with screwdriver. The
gasket and hose inlet connector required for connection is as the picture shown
below.
NOTE : The regulator to be affixed on LPG cylinder should have 300 mm SS
feature.
For Natural Gas Connection
WARNING : Natural gas connection should be done by an authorized service.
For natural gas connection, place a gasket in the nut at the edge of the natural
gas connection hose. To install the hose on the main gas pipe, turn the nut.
Complete the connection by doing a gas leakage control.
Gas hose passage way
Connect the appliance to the gas piping tap in the shortest possible route and in a way that ensures no gas
leakage will occur.
In order to carry on a tightness and sealing safety check ensure that the knobs on the control panel are closed and
the gas cylinder is open.
WARNING : While performing a gas leakage check, never use any kind of
lighter, match, cigarette or similar burning substance.
Apply soap bubbles on the connection points. If there is any kind of
leakage then it will cause bubbling.
While inserting the appliance into place ensure that it is on the same level
with the benchtop. If required, adjust the legs in order the make level with
the benchtop.
Use the appliance on a level surface and in a well ventilated environment.
WARNING : Before placing the appliance, check that the local distribution
conditions (gas type and pressure) conform to the product settings.
Figure 1
Figure 2