10
Electrical Connections
LOCAL AUTHORITY REQUIREMENTS
Installation is only permitted by an authorized person, and carried out according to instructions provided by
the manufacturer. Incorrect installation might cause harm and damage which the manufacturer accepts no
responsibility. The electrical connection can be found 30mm in from the rear edge and 280mm from the left
hand side (looking from the front).
INSTALLATION
This cooktop must be connected to a 220-240V 50Hz power supply. It is earthed via the cord.
Before carrying out the connection to the power supply, the voltage rating of the appliance (stamped on the
appliance identification plate) must be checked for correspondence to the available mains supply voltage,
and the mains electric wiring should be capable of handling the hob’s power rating (also indicated on the
identification plate);
The power point must be connected to a suitable earth wiring, in conformity to current safety regulations.
Ensure that the power supply is within 900mm of the cooktop. The power supply cord must not touch against
any hot surfaces and must be placed so that its temperature does not exceed 75 degrees C at any point
along its length.
The colours of the wires in the hob power cable may not correspond with the colours marked on the
terminals of your electrical plug .The plug should in any case be wired as follows:
—connect the green/yellow wire to the terminal marked with the letter E or the earth symbol or coloured
green/yellow;—connect the blue wire to the terminal marked with the letter N or coloured black;
—connect the brown wire to the terminal marked with the letter L or coloured red.
After having installed the appliance, the power switch or
power plug must always be in an accessible position.
Electrical connection diagram
N.B For connections to the mains power supply, never use
adapters, reductions or multiple power points as these may
overheat and catch fire.
In the event that installation should require modifications to the mains supply wiring system or if the power
plug is not suitable for the type of power point available, it is required that a qualified technician be called to
carry out substitution.
The technician will also have to verify that the cross-section of the electric cables on the power point match
the appliance’s power rating.
INSTALLATION
Note
: These tops are designed to be fitted into kitchen fixtures measuring 600 mm in depth.
In order to install the cooker top into the kitchen fixture, a hole with the dimensions shown on the cutting size
board has to be made, keeping in consideration the following:
Within the fixture, between the bottom side of the cooker top and the
upper surface of any other appliance or internal shelf there must be a
clearance of at least 30 mm;
Keep at least 200mm from the periphery of the burners to any side or
rear wall with combustible surfaces or keep the appliance sides at least
50mm from walls with non-combustible surfaces.
There must be a distance of at least 650 mm between the hob and any
extractor hood or wall cupboard positioned immediately above it. The
distance to an overhead exhaust fan must be at least 750mm.
The duplicate data plate should be fixed in an accessible position close
to the appliance (inside face of cupboard door, side of cabinet etc).
Note:
Keep a safe distance away from combustible constructions.
After installation, all burners should be tested individually and together to ensure correct operation.
