Omega OBO694XB, Instruction Manual

Page: 13 / 18

10
Accessories
The Wire Grid for Deep Trays
Make sure the wire grid is correctly placed within a deep tray. It is
recommended
to use this accessory for grilling steaks, meatballs and similar food.
The Shallow Tray
The shallow tray is best used for baking pastries. Put the tray into any rack
and push it to the end to make sure it is correctly placed.
The Wire Grid
The wire grid is best used for grilling or for processing food in oven-friendly
containers.
WARNING
Place the grid to any corresponding rack in the oven cavity correctly and
push it to the end.
You can use glass containers, cake pans and special oven trays suitable for use in your oven (available in kitchenware
shops). Pay attention to the information given by the supplier for use of this cookware. The information given below
should be implemented for enamelled containers.
If the food to be cooked does not completely cover the oven tray, if the food is taken out of the deep-freezer or if the
tray is used to collect the dripping juices of the foods during the grill operation, deformation might be observed on the
tray over time due to high temperatures forming during the cooking/baking operation. This is a normal, physical state
that results during the heat transfer. Do not leave a glass tray or container in a cold environment immediately after
cooking in them. Do not place them on cold and wet surfaces. Ensure that they slowly cool off by placing them on a
dry piece of cloth or wooden board, otherwise, the glass tray or container might break. If you are going to use the large
wire oven rack/grill, insert a tray into one of the lower racks to collect fat or oil. To make cleaning easier, add some
water into this tray. In a grilling operation, use the shelf in position 11 or 12.
Each wire grid and tray comes with a built-in safety feature to help minimise them being accidentally pulled fully out.
This comes in the way of a “step”, positioned part-way in from the rear of the accessory.
To fit them into the oven, push the wire grid or tray part way into the oven until the step “catches”, then angle the part
over the step & fully insert. To remove, repeat the operation in reverse.